• Ceramic Pre-filter
  1. Soak in cool water for ten minutes.
  2. Using the included grey scrub pad (or equivalent), scrub the top of the Ceramic Pre-filter using moderate pressure. You are removing a thin layer of ceramic material, this is normal and by design.
• Fluoride Filter
  1. Run water through the top of the filter until the water runs clear out the bottom.
  2. Shake the filter while running water through it. The purpose of this step is to remove any excess Granulated Activated Carbon (GAC) pieces. Place a white surface (e.g. a plate) in the sink under the filter. This will let you more easily see the black GAC pieces.
• Mineral Stones:
  1. Rinse the Mineral Stones.
  2. Boil the Mineral Stones for 1 - 2 minutes, then let air dry.

CLEANING / MAINTENANCE:

• Weekly:

  • Ceramic Pre-Filter - When the Ceramic Pre-filter is noticeably dirty or running slow, scrub the surface of the Pre-Filter with the grey sponge included in the box or another clean fine-textured sponge. Rinse under running tap water. This may be once a week or as needed. Some water sources have more sediment so more frequent cleaning may be required. The colour of a dirty Ceramic Pre-Filter depends on the quality of the source water. Do not use soap or detergent.

• 4-6 Months: We recommend routine cleaning of the entire system each time you change the Fluoride Filter or your 5-stage Filter (every 4-6 months).

  • Full System - Drain and disassemble the system. Use a cleaning solution made of 5 mL (1 tsp) natural bleach to 1L (4 cups) of water. Wash all plastic parts in cleaning solution. Rinse with clean tap water. Do not use cleaning solution for the Ceramic Pre-Filter and 5-Stage Filter.

  • Flouride / 5-Stage Filter - Replace.

  • Mineral Stones - Transfer stones into a pot. Boil stones for at least 1 minute to sanitize and condition. Drain the stones and lay out on a clean paper towel or towel to cool. Place stones into the bottom tank.